How to setting sending Sflow on an Enterasys switch?

Use the following commands to configure the sending of Sflow from an Enterasys switch to the OpMon Traffic Analyzer. In this configuration the sampling rate used will be 1 in 2048 packets, and the probe will occur every 20 seconds using UDP port 6343.

set sflow receiver 1 owner analyzer1 timeout 180000
set sflow receiver 1 IP_DO_OPMON_TRAFFIC_ANALYZER

#configure packet sampling instances on ports 1 through 12 
#assign to sFlow Collector 1 
set sflow port ge.1.1-12 sampler 1 
set sflow port ge.1.1-12 sampler maxheadersize 128
set sflow port ge.1.1-12 sampler rate 2048

#configure counter poller instances on ports 1 through 12 
#assign to sFlow Collector 1
set sflow port ge.1.1-12 poller 1
set sflow port ge.1.1-12 poller interval 20